Installation instructions brake caliper mount bgm PRO Vespa CNC Touring, 4-piston, radial for type Piaggio/Grimeca or LML

, , , , ,

Video Tutorial

Many bgm innovations were part of our Platonica project, in this video you can see them Disc brake and the brake caliper mount im bgm Tutorial.

Tutorial SC - New brake caliper mount bgm Vespa PX

 

Our professional brake caliper mount from bgm PRO Made in Italy: Allows the assembly of the radially mounted BGM PRO 4-piston brake caliper, which enables braking values ​​at motorbike level with fine dosing.

VESPA OR LML?
The brake caliper mount is available for Vespa or LML. The difference between the two types lies in the different dimensions of the speedometer drive. The selection of the right adapter therefore depends on the existing/used brake drum (Piaggio or LML).
Examples:

  • A Vespa PX (1985 model) that was subsequently converted to disc brakes with a Grimeca retrofit kit requires the PX adapter.
  • A Vespa PX (1985 model) that was subsequently converted to disc brakes with an LML fork requires the LML adapter.
  • A Vespa PX Disc (1998 model) requires the adapter type Vespa PX.
Go to Shop

 

Instructions

1. Put the O-ring on the axle and put it over the swingarm.
2. Put the shim on the axle.
3. Put the V-ring on the axle.

4. Grease the bearing of the brake caliper mount and put it on the axle.
5. Place the appropriate D-washer on the axle and align it with the recess in the axle.
6. Place the Ø 20mm circlip on the axle and make sure it is securely seated in the groove, then position the O-ring.

 

7. Put the brake drum on the axle and fasten it with a nut. Then secure with a safety cage and cotter pin. Attention, see step 13 before tightening the nut.

 

 

 

 

 

 

 

 

 

8. Fasten the brake caliper with the two screws and check the alignment with the brake disc.

9. Adjust the position of the brake caliper to the brake disc with the discs provided. Repeat steps 3 through 9 with the options until the caliper is centered over the disc as shown in Fig. 13. After the adjustment of the brake caliper mount, fasten the central nut of the brake drum with 90Nm. Tighten the brake caliper bolts to 16Nm.

DOWNLOAD PDF