Project Racer - Tuesday 21.02.2012/XNUMX/XNUMX

That had to work too!

... because whoever looks back on a successful 20-year existence this year ...

Exactly this morning at 10:00 our frame comes rolled into the yard - finally!

Everyone is excited to see what the good piece looks like, so first unpack and admire!

Unfortunately there is not too much time to look at every detail in peace, because the CS in Ried is approaching with great strides and time is of the essence.

So the step rails are attached directly - we use hammer rivets for this, as it should be.

The rivets are attached with a hammer drone. The waffle pattern creates the typical Piaggio character.

We had the strips and end pieces coated with black powder, because in the short time nobody was to be found who could "just" provide the same with a beautiful gold plating.

In my opinion, a very successful stopgap solution.

After moving in the bearings followed by the harness and the Bouwdenzug.

Last but not least, we get the engine from the P4 and install the rear disc brake system, which had to give way to the brake cable actuated drum for the test stand due to time constraints.

Our racer is cuddled up carefully - lights off - good night and see you tomorrow.