If you are not happy with the results below please do another search
The video and blog de hoy tratan sobre la medición del ángulo o tiempo de admisión. Los ángulos de admisión deben estar en un cierto rango, que se especifica en grados del cigüeñal. Como punto fijo, las mediciones siempre comienzan desde el punto muerto superior (PM). Por lo tanto, the area de entrada se divide […]
Our video and blog today is about measuring the inlet angle, also known as the inlet timing. The inlet angle should move in a certain range which is given in degrees crankshaft. As a fixed point, the measurements always start from the top dead center, or TDC for short. The entrance area is therefore divided into the values "before TDC" and [...]
Our video and blog today is about measuring the inlet angle, also known as the inlet timing. The inlet angle should move in a certain range which is given in degrees crankshaft. As a fixed point, the measurements always start from the top dead center, or TDC for short. The entrance area is therefore divided into the values "before TDC" and [...]
