Vespa handlebar end indicator LED white / black / orange with TÜV

Moto Nostra LED Vespa handlebar end indicators in a set with E-mark

Our Moto Nostra Vespa handlebar end indicator LED combines the classic design of Hella handlebar end indicators with modern LED technology. The Vespa handlebar indicator has high power LEDs on a circuit board fitted on both sides. Compared to conventional light sources, these emit a clear and brilliant light with almost no switch-on delay.

We offer the Vespa LED indicators individually or as a complete set with gas and switching tube. The glasses are of course available individually as spare parts in all colors!

DC AC

The handlebar indicators are suitable for all 6 volt or 12 volt power sources, regardless of whether direct current (DC) or alternating current (AC)! Clever integrated control electronics enable the optional operation on both types of voltage. Even at low voltage (e.g. when idling) they offer a constant flashing signal.

WITH E-MARK / TÜV

The indicators naturally have an E-mark / E-mark on the indicator glasses, which are available in different colors. The turn signals are E-marked Can be used immediately in traffic and no longer have to be approved by the TÜV!

USE

The indicators fit on all vehicles on which handlebar end indicators have already been used at the factory. Many Vespa vehicles built before around 1980 can usually be retrofitted without any problems. We offer corresponding sets for this.

• TYPE: handlebar end indicator Hella (originally used on Vespa V50, 90 Racer, ET3, Sprint, Rally)
• LIGHT SOURCE: LED (permanently integrated)
• VOLTAGE: 6V and 12V AC / DC available
• WATT: 3,6Watt (+ series resistor)
• TEST MARK: E-mark (E4)
• AVAILABLE COLOURS:
  • original (orange),
  • tinted (black)
  • clear (white)

CONCLUSION VESPA HANDLEBAR END INDICATOR LED

1. higher security
2. Modern technology
3. unchanged classic look
4. optional modern look through black or white glasses
5. Approval for public road traffic

The new handlebar end indicators are a useful update for every oldie. Robust LED technology, paired with a classic, original look result in a safety plus without this being recognizable from the outside!

PreviousNext

12345678910111213141516171819

OUR TIP

The LED indicators use a series resistor to operate on the existing on-board network / indicator relay. This is necessary in order to adequately address conventional (mechanical) flasher relays and to achieve even timing. If you have optimized your on-board network or still want to, you can remove the series resistor (which is located outside the indicator housing in the supply line) when using an electronic flasher relay. The indicator glasses also fit conventional indicators, but the test mark is only valid when used with the Moto Nostra LED indicator.